- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Accepting the End User License Agreement
- Run the configuration wizard
- Using the system configuration wizard
- License
- Network
- Passphrase
- File System
- Settings
- Selecting and configuring Secure Remote Services delivery
- Installation Troubleshooting
- Add Storage Capacity
PowerProtect DD6400 System Installation and Storage Expansion Guide
Connecting disk shelf power cables
Prerequisites
Each disk shelf has two power supplies. Connect each power supply to redundant AC power sources, so the loss of one power supply or one power source does not cause the shelf to power off.
About this task
ES40 shelves have one power cord per power supply for a total of two power cords.
Steps
- Plug the power cords into both power supplies on the disk shelf.
- If the disk shelf has a retention bail, secure the power cord with the retention bail. The bail prevents the power cord from pulling out of the connector.
- For ES40 shelves, connect each power cord to redundant power sources in the rack.
Figure 1. ES40 power cabling 
- Repeat the preceding steps for each shelf in the rack.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\