- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Accepting the End User License Agreement
- Run the configuration wizard
- Using the system configuration wizard
- License
- Network
- Passphrase
- File System
- Settings
- Selecting and configuring Secure Remote Services delivery
- Installation Troubleshooting
- Add Storage Capacity
PowerProtect DD6400 System Installation and Storage Expansion Guide
Add Storage Capacity
The system supports capacity expansion operations by adding new disk shelves while the system is powered on. The chapter contained in this part provides overview information and instructions to verify the system health before adding storage to the system.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\