- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Configure iDRAC
- Configure serial over LAN (SOL)
- Change the iDRAC network port
- Enable administrative communication
- Accepting the End User License Agreement
- Run the configuration wizard
- Using the system configuration wizard
- License
- Network
- Passphrase
- File System
- Settings
- Selecting and configuring Secure Remote Services delivery
- Installation Troubleshooting
- Add Storage Capacity
PowerProtect DD6400 System Installation and Storage Expansion Guide
Using the system configuration wizard
The DD System Manager wizard guides you through a simplified configuration to get your system operating quickly. After you complete the basic configuration with a wizard, you can use DD System Manager and the CLI to further configure your system.
Steps
- Select .
- Use the controls at the bottom of the Configuration Wizard dialog box to select which features to configure and to advance through the wizard.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\