Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

PowerProtect DD6400 System Installation and Storage Expansion Guide

PDF

Secure the rail assemblies to the cabinet

The supplied screws and washers are used to secure the rail assemblies to the front and rear of the cabinet.

About this task

NOTE:For square hole cabinets, install the supplied conical washer before installing the screw. For unthreaded round hole cabinets, install only the screw without the conical washer.

Steps

  1. Align the screws with the designated U spaces on the front and rear rack flanges.
    Ensure that the screw holes on the tab of the system retention bracket are seated on the designated U spaces.
  2. Insert and tighten the two screws using the Phillips #2 screwdriver.
    Figure 1. Installing screws
    Image shows installing screws to secure rail assemblies in the cabinet

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\