Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

PowerProtect DD6400 System Installation and Storage Expansion Guide

PDF

Install the rails

About this task

The rails are labeled left and right, and cannot be interchanged. The front side of each rail is labeled Left Front or Right Front when viewed from the cabinet front.

Steps

  1. Determine where to mount the system, and use masking tape or a felt-tip pen to mark the location at the front and back of the cabinet.
    NOTE:Install the left rail assembly first.
  2. Fully extend the rear sliding bracket of the rail.
  3. Position the rail end piece labeled Left Front facing inward and orient the rear end piece to align with the holes on the rear cabinet flanges.
  4. Push the rail straight toward the rear of the rack until the latch locks in place.
    Figure 1. Installing the rear end of the rail
    Image shows installing rail to cabinet rear flange
  5. For the front end piece, rotate the latch outward and pull the rail forward until the pins slide into the flange, and release the latch to secure the rail in place.
    Figure 2. Installing the front end of the rail
    Image shows installing rail to cabinet front flange
  6. Repeat the preceding steps to install the right rail assembly.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\