To make sure that the shelf firmware is updated properly, power cycle DS60 shelves after installing them. Complete the following tasks to power cycle the shelves.
NOTE The KB article
Data Domain Restorers with DS60 shelves may encounter a kernel panic due to an LCC firmware change, available on
https://support.emc.com, provides additional information.
Steps
Run the
system poweroff command to shutdown the Data Domain system.
Remove all AC power cords from all DS60 shelves for 30 seconds.
Reconnect the AC power cords to the DS60 shelves and wait five minutes for the shelves to power up and stabilize.
Power on the Data Domain system
Log back in as a sysadmin user.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\