- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Add Storage Capacity
Data Domain DD6300 System Installation and Storage Expansion Guide
Installing the shelf on the rails
About this task
WARNING
The enclosure is heavy and should be installed into or removed from a rack by two people. To avoid personal injury and/or damage to the equipment, do not attempt to lift and install the enclosure into a rack without a mechanical lift and/or help from another person.
Steps
- With help from another person, lift the enclosure and, from the front of the cabinet/rack, slide the enclosure onto the rails.
Figure 1. Sliding the enclosure onto the rails 
When the enclosure slides to the back of the cabinet, the rear tabs on the rails insert into the two notches in the rear of the enclosure. The tabs secure and support the rear of the enclosure.If the chassis does not slide all the way into the cabinet, you may need to further loosen the screws that hold the rear of the rails in place, then adjust the rails to allow the tabs to fit into the notches.
Figure 2. Rail tabs securing the rear of the enclosure 
- Once the enclosure is completely seated into the rear tabs, secure the enclosure, tighten the screws (two on each rail) that secure the rails to the channels.
- Secure the front of the enclosure to the front vertical channels with four screws (two per side), but do not tighten the screws until they are all in place.
Figure 3. Securing the front of the enclosure 
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\