- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Add Storage Capacity
The captive shoulder screws attach the shelf to the cabinet.
Refer to the following table for installation in third-party racks:
Truss head screw from kit | Part number and description | Suggested use |
---|---|---|
![]() | 036-032-010
Screw, M5-0.8x12, Truss Head Phillips with patch | Can be used in racks and third-party non-threaded hole racks. |
![]() | 036-032-011
Screw, M6-1.0x12, Truss Head Phillips with patch | Can be used in non- racks. |
![]() | 036-032-009
Screw, 10-32x.5, Truss Head Phillips with patch | Can be used in non- racks. |
![]() | 036-032-012
Screw, 12-24x.5, Truss Head Phillips with patch | Can be used in non- racks. |
To secure a top cover that does not have any mounting hardware, use the screws or pins from the kit that accompanies the device. These screws secure the shelf cover and prevent the cover from coming out of the cabinet during operation. Secure the top cover to the rack as follows: