- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Add Storage Capacity
Data Domain DD6300 System Installation and Storage Expansion Guide
Document purpose
This installation guide provides instructions for installing the hardware associated with PowerProtect systems. Systems are shipped to the customer site either pre-installed in a rack (factory-racked) or as separate components to install in an existing rack at the site (field-installed). This guide provides instructions for both types of installation.
This document is intended for customers or Dell EMC Support personnel who are qualified to install PowerProtect systems.
Field-installed systems
To install PowerProtect systems in an existing rack at the customer site, follow all the instructions in this document to rack, cable, and configure the system.
Factory-racked systems
Factory-racked systems are pre-installed in the rack with the cables already connected. Follow the instructions in Configure System for Use to configure factory-racked systems.
The following documents, available from the Online Support website, provide additional information about factory-racked systems:
- Dell EMC 40U-P Cabinet Site Preparation Guide
- Dell EMC 40U-P Cabinet Unpacking and Setup Guide
- Dell EMC Titan S Site Preparation Guide
- Dell EMC Titan S Unpacking and Setup Guide
- Dell EMC Data Domain Rack Service Guide
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\