Enable data transfer Ethernet connectivity. Repeat for each connection.
If using 1 Gb copper Ethernet, attach a Cat 5e or Cat 6 copper Ethernet cable to an RJ-45 Ethernet network port (start with ethMa and go up).
If using 10 Gb copper Ethernet with an SFP+ connector, use a qualified SFP+ copper cable.
If using 1/10 Gb fiber Ethernet, use MMF-850nm cables with LC duplex connectors.
For 10GBaseT connections, use Cat6a S-STP Ethernet cables.
Enable data transfer Fibre Channel (FC) connectivity. Repeat for each connection.
Attach a Fibre Channel fiber optical cable (LC connector) to an I/O module port on the controller, and attach the other end (LC connector) to an FC switch or to an FC port on your server.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\