- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Add Storage Capacity
Only use this procedure if the rack is 34 inches to 36 inches deep and/or the rack has tapped holes that are M5, M6, 10/32, or 12/24.
The front edge of each rail is stamped L or R for left and right sides, when facing the front of the rack. Since the brackets cover these markings, make a note as to which rack is L and which rack is R.
Use a #2 Phillips screwdriver with a shank diameter less than 7.0 mm and the wrench that was included in the kit to tighten the nuts.