- Notes, cautions, and warnings
- Introduction and Preparation
- Install the System in the Rack
- Install the Disk Shelves in the Rack
- Connect Cables and Power On
- Configure System for Use
- Add Storage Capacity
Network Configuration Configure Network at this time (yes|no) [no]: yes
Use DHCP Use DHCP for hostname, domainname, default gateway and DNS servers? (At least one interface needs to be configured using DHCP) (yes|no|?)
Enter the hostname for this system (fully-qualified domain name)[]:
Domainname Enter your DNS domainname []:
Ethernet port ethMa Enable Ethernet port ethMa (yes|no|?) [no]: yes Use DHCP on Ethernet port ethMa (yes|no|?) [no]: Enter the IP address for ethMa [192.168.10.185]: Enter the netmask for ethMa [255.255.255.0]: Ethernet port ethMb Enable Ethernet port ethMb (yes|no|?) [no]: no
Default Gateway Enter the default gateway IP address: 192.168.10.1
IPV6 Default Gateway Enter the ipv6 default gateway IP address:
DNS Servers Enter the DNS Server list (zero, one, two or three IP addresses): 192.168.10.1