- Notes, cautions, and warnings
- Revision history
- Preface
- Getting Started
- Introducing DDVE
- Deploying DDVE
- Prerequisites for deploying DDVE on Azure
- Deploying DDVE from the Azure Marketplace
- Adding metadata disks in Azure
- Resizing the DDVE instance in Azure
- Converting metadata disk type
- Completing Initial DDVE Configuration
- Administering DDVE
- Best Practices for Working with DDVE in the Cloud
- Networking Best Practices for DDVE in the Cloud
- Installing and Configuring DDVE on Block Storage in the Cloud
Dell EMC PowerProtect DDVE in the Azure Cloud 7.8 Installation and Administration Guide
Changing authentication to OAuth 2.0
You can use DDSM or CLI to change the authentication method to OAuth 2.0.
Before changing the authentication method to OAuth 2.0, observe these prerequisites:
| Managed identity type | Steps |
|---|---|
| User-assigned managed identity | Create a user-assigned managed identity, assign the Storage Blob Data Owner to it, and attach the identity to the DDVE.
For steps, see Configure user-assigned managed identity. |
| System-assigned managed identity | Enable a system-assigned managed identity for a DDVE and assign the Storage Blob Data Owner role to the storage account.
For steps, see Configure system-assigned managed identity. |
Change the authentication method to OAuth 2.0:
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\