It is important that the time on the DDVE instance is correctly synchronized. Any drift in time might impact the object store communication.
About this task
System time is required for secure communication. We recommend that you sync time with the NTP server for DDVE in Azure. While performing initial configuration of the DDVE system, you can enable NTP and configure the NTP server. If you do not use the CLI configuration wizard to perform initial configuration, you can use the
ntp enable command on the
DDOS command line. For more information about time sync for Linux VMs in Azure, refer to
Time sync for Linux VMs in Azure.
Steps
Under
Administration, select
Settings.
Select
More Tasks > Configure Time Settings.
Under
NTP, select
Manually Configure and add your own NTP servers.
Using CLI, run the following commands to configure NTP on DDVE.
ntp add timeserver
ntp enable
ntp sync
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\