- Notes, cautions, and warnings
- Revision history
- Preface
- Getting Started
- Introducing DDVE
- Deploying DDVE
- Prerequisites for deploying DDVE on Azure
- Deploying DDVE from the Azure Marketplace
- Adding metadata disks in Azure
- Resizing the DDVE instance in Azure
- Converting metadata disk type
- Completing Initial DDVE Configuration
- Administering DDVE
- Best Practices for Working with DDVE in the Cloud
- Networking Best Practices for DDVE in the Cloud
- Installing and Configuring DDVE on Block Storage in the Cloud
Dell EMC PowerProtect DDVE in the Azure Cloud 7.8 Installation and Administration Guide
Adding disks in Azure
Prerequisites
- Ensure that you have enough licensed capacity available to add new capacity to DDVE.
- Ensure that the DDVE instance can support the new capacity. If the new capacity is more than the DDVE instance supported capacity, you must upgrade the DDVE instance.
- New block storage for the DDVE must meet the following requirements:
- The minimum size of the first data disk is 512 GiB.
- The minimum size of subsequent data disks is 1 TiB.
- The recommended size for all data disks is 1 TiB. For example, if 10 TiB of capacity are required, configure 10 x 1 TiB data disks.
About this task
A 10 GiB vNVRAM disk is created automatically after you deploy DDVE in Azure.
Next steps
NOTE The virtual disk cannot be resized. Create a new virtual disk to add additional storage to the virtual machine.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\