- Notes, cautions, and warnings
- Revision history
- Preface
- Getting Started
- Introducing DDVE
- Deploying DDVE
- Completing Initial DDVE Configuration
- Administering DDVE
- Best Practices for Working with DDVE in the Cloud
- Networking Best Practices for DDVE in the Cloud
- Installing and Configuring DDVE on Block Storage in the Cloud
Dell EMC PowerProtect DDVE on Google Cloud Platform 7.9 Installation and Administration Guide
Changing authentication method to OAuth 2.0
You can use the DDSM or CLI to change the cloud storage authentication method from HMAC to OAuth 2.0.
Prerequisites
- Create the service account with the correct privileges as described in Using OAuth 2.0 (recommended).
- Change the service account from the GCP console as described in Change service account from GCP console.
NOTE Converting the authentication method from OAuth 2.0 to HMAC is not allowed.
Steps
- To use DDSM to change to OAuth 2.0, see Using DDSM.
- To use CLI to change to OAuth 2.0, see Using CLI.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\