- Notes, cautions, and warnings
- Revision history
- Preface
- Getting Started
- Introducing DDVE
- Deploying DDVE
- Completing Initial DDVE Configuration
- Administering DDVE
- Best Practices for Working with DDVE in the Cloud
- Networking Best Practices for DDVE in the Cloud
- Installing and Configuring DDVE on Block Storage in the Cloud
Dell EMC PowerProtect DDVE on Amazon Web Services 7.9 Installation and Administration Guide
Upgrading M5 instance type
You can upgrade the current M5 instance type to higher capacity supported configuration.
About this task
NOTE Instance upgrade is not supported for DDVE with block storage as it supports a maximum capacity of 16 TB.
Steps
-
Power off the system using the
system poweroff command.
From the AWS console, check that the DDVE instance is in the stopped state.
- Select .
- Select the new instance type and click Apply.
- Power on the DDVE from the AWS console.
- Once the DDVE is powered on, run the command system vresource show to verify the new instance configuration.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\