To configure PowerProtect DD Virtual Edition (DDVE) and storage, use the bucket that was created during the
deployment.
You can find the bucket in the AWS UI. Under
Services, go to
CloudFormation > Stacks > <your stack>. Click the
Outputs tab to list the outputs, which include the S3 bucket.
For information about how to configure DDVE and storage, and for how to restore data to the production system, see the following publications that are available at
Dell Online Support:
PowerProtect DD Virtual Edition on Amazon Web Services Installation and Administration Guide
Dell PowerProtect Cyber Recovery Product Guide
NOTE:
You can access the DDVE UI directly after you log in to the jump host.
You cannot access the DDVE command-line interface (CLI) directly from the jump host by using SSH. Use SSH to access the
Cyber Recovery management host. Then, from the
Cyber Recovery management host, use SSH to access the DDVE CLI.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\