- Notes, cautions, and warnings
- Introduction to Dell Command | PowerShell Provider 2.8.0
- System requirements and prerequisites for Dell Command | PowerShell Provider 2.8.0
- Download and installation steps for Dell Command | PowerShell Provider 2.8.0
- Getting started with Dell Command | PowerShell Provider 2.8.0
- Importing Dell Command | PowerShell Provider
- Navigating using the Windows PowerShell console
- Supported cmdlets in Dell Command | PowerShell Provider
- Custom functions in Dell Command | PowerShell Provider
- Parameters supported in Dell Command | PowerShell Provider
- Configuring attributes using Dell Command | PowerShell Provider
- Features supported in Dell Command | PowerShell Provider
- Using the AutoOn feature
- Using the AdvanceBatteryChargeConfiguration feature
- Using the PrimaryBattChargeCfg feature
- Using the PeakShiftDayConfiguration feature
- Using the Keyboard Backlight Color feature
- Using the BootSequence feature
- Using the BIOS password feature
- Using the HardDisk Drive password feature
- Using TpmSecurity feature
- Using ForcedNetworkFlag feature
- Desired State Configuration (DSC) for Dell Command | PowerShell Provider
- Setting up Dell Command | PowerShell Provider 2.8.0 in Windows Preinstallation Environment
- Accessing help for Dell Command | PowerShell Provider 2.8.0
- Frequently asked questions for Dell Command | PowerShell Provider 2.8.0
- Troubleshooting scenarios for Dell Command | PowerShell Provider 2.8.0
- Accessing documents from the Dell EMC support site
Dell Command | PowerShell Provider Version 2.8.0 User's Guide
Configuring attributes using Dell Command | PowerShell Provider
To configure system BIOS settings using Dell Command | PowerShell Provider attributes:
- Set-location to DellSMBIOS: drive. See Dell Command | PowerShell Provider drive.
-
Verify the current state of the attribute by running the following command: Get-Item -Path <path to the attribute>. See
Format of the path.
The command displays the Current Value, Possible Values and Description of the attribute you want to configure.
- To set the attribute, run the following command: Set-Item –Path <path to the attribute> <possible value> -Password <password>. See Password parameters.
Example: To enable the Numlock attribute when password is set, run the following command:
Set-Item –Path .\POSTBehavior\Numlock Enabled -Password <password>
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\