- Notes, cautions, and warnings
- Introduction to Dell Command | Monitor 10.2
- System requirements for Dell Command | Monitor 10.2
- Prerequisites for Dell Command | Monitor 10.2
- Installing Dell Command | Monitor 10.2 for systems running on Microsoft Windows
- Installing Dell Command | Monitor 10.2 for systems running on Linux
- Upgrading Dell Command | Monitor 10.2 for systems running on Microsoft Windows
- Upgrading Dell Command | Monitor 10.2 for systems running on Linux
- Uninstalling Dell Command | Monitor 10.2 for systems running on Microsoft Windows
- Uninstalling Dell Command | Monitor 10.2 for systems running on Linux
- Uninstalling Dell Command | Monitor using Deb Package
- Uninstalling Dell Command | Monitor using an RPM package
- Uninstalling Dell Command | Monitor version 9.1 and 9.1.2 from Dell Edge Gateway 5000 or 3000 series systems running Ubuntu Core 15.04 using Snap package
- Uninstalling Dell Command | Monitor from Dell Edge Gateway 3000 series systems running Ubuntu Core 16 using Snap package
Dell Command | Monitor Version 10.2 Installation Guide
Uninstalling Dell Command | Monitor using the MSI file
-
Right-click the
MSI file, and click
Run as administrator.
- For 32–bit operating systems, select Command_Monitor_x86.msi
- For 64–bit operating systems, select Command_Monitor_X64.msi
- In the Welcome to the InstallShield Wizard for Dell Command | Monitor , click Next.
- In the Program Maintenance, select Remove and then click Next.
- In the confirmation screen, click Yes.
- In the InstallShield Wizard Complete screen, click Finish to complete the uninstallation and close the screen.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\