- Notes, cautions, and warnings
- Introduction
- Using Dell Command | Integration Suite for System Center
- The Dell Command | Intel vPro Out Of Band Application
- Software Prerequisites
- Configuring WinRM on Client Systems
- Launching The Dell Command | Intel vPro Out of Band Application
- Account Setup
- Client Discovery
- Settings
- Remote Provisioning
- USB Provisioning
- Indications
- Client Configuration
- Operations
- Generating Reports
- Task Queue
- Troubleshooting
- Related Reference
Dell Command | Integration Suite for System Center Version 5.0 User’s Guide
Wipe Client Data
CAUTION: This
operation deletes all the data on your client systems.
NOTE: The remote-wipe of
client hard drive may take several hours to complete.
The Wipe Client Disk feature remotely erases data on supported
client system's hard drives. - Launch the Dell Command | Intel vPro Out of Band application.
- Click .
- After selecting Wipe Client Data, you can perform one of the following actions:
- Schedule — to schedule a
time for client system's hard disk wipe. For more information, see Scheduling
Wipe Client Data.NOTE: To schedule a Remote Wipe Client Data operation, the client must be accessible through the network.
- Retrieve — to retrieve status of client system's hard disk wipe. For more information, see Retrieving Wipe Client Data Status.
- Schedule — to schedule a
time for client system's hard disk wipe. For more information, see Scheduling
Wipe Client Data.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\