Lift the latch and, disconnect the 2 Input/Output cables from the connector on the system board [1].
Lift the latch and, disconnect the touchpad cable from the connector on the system board [2].
Release the tabs and, disconnect the keyboard cable from the connector on the system board [3].
Disconnect speaker cable from the connector on the system board [4].
Remove the single (M2x4) screw that secures the eDP bracket to the system board [1].
Remove the eDP bracket away from the system [2].
Peel the adhesive tape that secures the eDP cable to the system board [3].
Lift the latch and, disconnect the eDP cable from the connector on the system board [4].
Peel the adhesive tape that secures the cable to the system [5].
Remove the single (M2x4) screw that secures the system board bracket to the system [1].
Lift the system board bracket [2] and release the hook on the bracket from the retention tab in the system [3].
Remove the 3 (M2x3) screws that secure the system board to the system [1].
Lift the system board away from the system [2].
NOTE In the event of system board replacement, the technician
needs to run the RMA Shim. The RMA Shim USB Key is dispatched with
service replacement System Board. A tech sheet kitted with the RMA
Shim USB Key contains instructions to run the RMA Shim.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\