NOTE: The screw cover on the base cover is made up of a mylar sticker.
To remove this screw, use a regular philips driver and puncture the
mylar cover. Once the mylar caps are removed it cannot replaced, and
the screws will be exposed from that point forward.
Loosen the M2.5x7 captive screws that secure
the base cover to the computer [2] .
Pry the base cover from the edge.
NOTE: You may need a 3c plastic scribe to pry the base cover from the edge.
Lift the base cover away from the computer.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\