- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Chromebook 3110
- Base cover
- SIM card
- Wireless Wide Area Network (WWAN) card
- Battery
- Battery cable
- Keyboard
- Display assembly
- System board
- Speakers
- Display bezel
- Display panel
- Front-facing camera
- Display hinges
- Display cable
- Display back-cover and antenna assembly
- Palm-rest assembly
- Troubleshooting
- Getting help and contacting Dell
Chromebook 3110 Service Manual
Installing the display hinges
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the display hinges and provides a visual representation of the installation procedure.
Steps
- Align the screw holes on the display hinges with the screw holes on the display back-cover.
- Replace the two screws (M2.0x3.0) and the four screws (M2.5x2.5) to secure the display hinges to the display back-cover.
- Adhere the four pieces of aluminum foil to secure the display hinges.
- Adhere the conductive tape on the left display hinge to secure the display cable in place.
NOTE:For Chromebook 3110 computers shipped with WWAN, route the display cable along the routing channels at the bottom-left side of the display back-cover and then adhere the piece of conductive tape to secure the display cable in place.
Next steps
- Install the display panel.
- Install the display bezel.
- Install the display assembly.
- Install the WWAN card for computers enabled with 4G LTE.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\