- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Chromebook 3110
- Base cover
- SIM card
- Wireless Wide Area Network (WWAN) card
- Battery
- Battery cable
- Keyboard
- Display assembly
- System board
- Speakers
- Display bezel
- Display panel
- Front-facing camera
- Display hinges
- Display cable
- Display back-cover and antenna assembly
- Palm-rest assembly
- Troubleshooting
- Getting help and contacting Dell
Chromebook 3110 Service Manual
Installing the display bezel
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display bezel and provide a visual representation of the installation procedure.
Steps
- Align and place the display bezel on the display assembly.
- Starting from the top corner, press on the display bezel and work around the entire bezel until it clicks onto the display assembly.
- Press both the hinge caps of the display bezel until it clicks into place.
- Replace the four screws (M2.5x3.8) to secure the display bezel to the display assembly.
- Adhere the stickers on the screws that secure the display bezel.
NOTE:A new set of stickers is included with the replacement display bezel. When replacing the new display bezel, adhere the new stickers over the screws once the screws have been secured.
Next steps
- Install the display assembly.
- Install the WWAN card for computers enabled with 4G LTE.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\