- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Chromebook 3110 2-in-1
- Base cover
- Battery
- Battery cable
- Keyboard
- Display assembly
- System board
- Speakers
- World-facing camera cable
- World-facing camera
- Display panel
- Front-facing camera
- Display hinges
- Display cable
- Display back-cover and antenna assembly
- Palm-rest assembly
- Troubleshooting
- Getting help and contacting Dell
Chromebook 3110 2-in-1 Service Manual
Installing the world-facing camera cable
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:The following procedure is applicable only for computers shipped with a world-facing camera.
The following image indicates the location of the world-facing camera cable and provides a visual representation of the installation procedure.
Steps
- Align and place the world-facing camera cable on the palm-rest assembly.
- Connect the world-facing camera cable to the connector on the world-facing camera module.
Next steps
- Install the system board.
- Install the base cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\