- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Chromebook 3110 2-in-1
- Base cover
- Battery
- Battery cable
- Keyboard
- Display assembly
- System board
- Speakers
- World-facing camera cable
- World-facing camera
- Display panel
- Front-facing camera
- Display hinges
- Display cable
- Display back-cover and antenna assembly
- Palm-rest assembly
- Troubleshooting
- Getting help and contacting Dell
Chromebook 3110 2-in-1 Service Manual
Removing the base cover
Prerequisites
- Follow the procedure in Before working inside your computer.
About this task
The following images indicate the location of the base cover and provide a visual representation of the removal procedure.
NOTE:For Chromebook 3110 systems shipped with WWAN, the base cover is secured using Torx 5 (not Phillips #0) screws.
Steps
- Loosen the nine captive screws that secure the base cover to the palm-rest assembly.
- Using a plastic scribe, pry the base cover from the U-shaped indents at the top and continue working on the sides to open the base cover.
- Lift and remove the base cover off the palm-rest assembly.
- Use the pull tab to disconnect the battery cable from the connector system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\