- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Technology and components
- Troubleshooting
- Getting help and contacting Dell
Dell Chromebook 3100 Service Manual
Installing the display assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display assembly and provides a visual representation of the installation procedure.
Steps
- Place the chassis on a plane surface.
- Align the display assembly with the screw holders on the system.
- Replace the six display hinge bracket screws (M2.5x5) to secure the display assembly to the system.
- Lift the system and close the display.
- Adhere the conductive tape to secure the display cable to the system board.
NOTE For Chromebook 3100 models with LTE capabilities, the piece of conductive tape on display cable must be adhered onto display hinge bracket and the display cable must be adhered onto the system board.
- Connect the display cable to the connector on the system board and close the lock.
- Place the display cable bracket to secure the display cable.
- Replace the single (M2x4) screw that secures the display cable bracket to the system.
- Connect the two antennas to the WLAN module
- Align and place the WLAN bracket on the system board.
- Replace the screw (M2x3) to secure the WLAN bracket on the system board.
Next steps
- Install the WWAN card for 4G LTE enabled systems.
- Install the base cover.
- Follow the procedure in after working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\