Align the display assembly with the screw holders on the system [1].
Replace the six (M2.5x5.0) display hinge bracket screws that secure the display assembly to the system [2].
Lift the system and close the display.
Connect the display cable to the connector on the system board [1].
Affix the adhesive tape to secure the display cable to the system [2].
Place the display cable bracket to secure the display cable [3].
Replace the single (M2.0x4.0) screw that secures the display cable bracket to the system [4].
Connect the EMR cable to the connector on the system board [1].
Connect the wireless antennas to the wireless module [2].
Place the wireless bracket to secure the wireless antennas and replace the single (M2.0x3.0) screw that secures the wireless bracket to the system [3, 4].