Behavior when a drive is connected to a BOSS-N1 controller
Table 1. Behavior when a drive is connected to a BOSS-N1 controller Behavior when a new drive is attached to a BOSS-N1 controller.
BOSS-N1 controller security mode
|
Fresh SED
|
Migrated SED (drive secured using another server)
|
Non-SED
|
Enabled
|
iDRAC assigns key and secures it.
|
iDRAC reads the key ID from drive:
- If the security configuration matches, iDRAC unlocks the drive.
- If the security configuration does not match, the drive stays in locked state.
|
The BOSS-N1 controller marks the drives as failed.
|
Disabled
|
BOSS-N1 can access the SED but will use the drive in an unsecured mode.
|
Drive stays in the locked state.
|
The BOSS-N1 controller can access the drive and use it.
|
NOTE: When the controller security mode is enabled, only secure unlocked drives can be used to create a VD.
Data is not available for the Topic