Installing the
Avamar Plug-in for Oracle on Windows
Install the
Avamar Plug-in for Oracle on both Windows stand-alone systems and MSCS two-node clusters. In a cluster, install the
Avamar Plug-in for Oracle on both nodes and in the same directory on each node.
Prerequisites
The
Avamar Plug-in for Oracle is automatically installed in the same folder as the
Avamar Client for Windows.
If the Oracle software is installed with the New Windows User, ensure that the
Avamar Plug-in for Oracle software is installed outside of the default path. For example,
C:\Program Files\avs.
If UAC is enabled on the client computer, you must start the setup wizard by using administrator privileges. Otherwise, the software does not install correctly. This procedure provides one method to bypass UAC. The Microsoft documentation provides other methods and additional information.
Steps
Log in to the Oracle server as an administrator.
Go to the temporary directory that contains the installation files that you downloaded in
Downloading the software.
Start the
Avamar Plug-in for Oracle installation:
If UAC is disabled, double-click the installation package to open it.
If UAC is enabled, open a command prompt as an administrator, change directory to the location of the installation package, and then type the following command:
The
Ready to install Avamar Backup Plug-in for Oracle page appears.
Click
Install.
The
Installing Avamar Backup Plug-in for Oracle page appears. A status bar shows the installation’s progress. After the installation completes, the
Completed the Avamar Backup Plug-in for Oracle Setup Wizard page appears.
Click
Finish.
In a cluster, repeat this installation procedure on each node.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\