Using the System Setup option, you can configure the BIOS settings, iDRAC settings, and device settings of the system.
Access system setup by using one of the following interfaces:
UI - Click
Configurations and then
BIOS Settings.
Text browser - Use the
Console Redirection.
Steps
To view System Setup, power on the system and press
F2.
NOTE:If the operating system begins to load before you press
F2, wait for the system to finish booting, and then restart the system and try again.
Click
System Setup Main Menu. The options available are described in the following table.
Table 1. System Setup Main Menu This table describes the options available within the System Setup Main Menu.
Option
Description
System BIOS
Configure the BIOS settings.
iDRAC Settings
This option enables you to configure the iDRAC settings. The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using the Unified Extensible Firmware Interface (UEFI). You can enable or disable various iDRAC parameters by using the iDRAC settings utility. For more information about this utility, go to the
Dell Support site and select the version and series of iDRAC that you have installed.
Device Settings
This option enables you to configure device settings for devices such as storage controllers or network cards.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\