Run the Embedded System Diagnostics from the Dell Lifecycle Controller
About this task
To run the Embedded System Diagnostics from the Dell Lifecycle Controller, perform the following steps:
Steps
During the boot cycle, press
F10.
Select
Hardware Diagnostics
and then
Run Hardware Diagnostics.
Figure 1. Hardware Diagnostics screen The
ePSA Pre-boot System Assessment window displays, lists the devices that are detected in the system, and then runs the diagnostic test on the detected devices.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
