- Notes, cautions, and warnings
- Revision history
- Introduction
- Overview
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- Set up the system
- Dell Lifecycle Controller
- Boot Manager
- Configuration information
- System diagnostics and indicator codes
- Additional support
Dell APEX Cloud Platform MC-760 Hardware Requirements and Specifications
Run the Embedded System Diagnostics from Boot Manager
Run the Embedded System Diagnostics (ePSA) if your system does not boot.
Steps
- During the boot process, press F11.
- Use the up and down arrow keys to select
System Utilities, and then
Launch Diagnostics.
Figure 1. System Utilities and Launch Diagnostics options in Boot Manager 
- Alternatively, during the system boot process, press
F10 and select
Hardware Diagnostics, and then
Run Hardware Diagnostics.
The ePSA Pre-boot System Assessment window displays, lists all the devices that are detected, and runs the diagnostic test on the detected devices.
- After the testing is complete, click Results, System Health, Configuration, and then the Event Log tabs to review the results.
- Once you have reviewed the information, close the Embedded System Diagnostics utility by selecting the Exit option in the upper right corner.
- Select OK to close the Embedded System Diagnostics utility.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\