This section describes the error messages that are displayed on the screen during POST or captured in the system event log (SEL), or LifeCycle (LC) log.
The following table provides information about the HWC8010 error message.
Table 1. Error message HWC8010This table provides information about the HWC8010 error message.
Error code
HWC8010
Message
The System Configuration Check operation that is resulted in the following issue involving the indicated component type
Arguments
Riser, floating card (fPERC, adapter PERC, BOSS), backplane, processor, cable, or other components
Detailed Description
The issue that is identified in the message is observed in the System Configuration Check operation.
Recommended Response Action
Do the following and retry the operation:
Disconnect the input power.
Check for proper cable connection and component placement. If the issue persists, contact the service provider.
Category
System Health (HWC = Hardware Config)
Severity
Critical
Trap/EventID
2329
The following table provides information about the HWC8011 error message.
Table 2. Error message HWC8011This table provides information about the HWC8011 error message.
Error code
HWC8011
Message
The System Configuration Check operation that is resulted in multiple issues involving the indicated component type
Arguments
Riser, floating card (fPERC, adapter PERC, BOSS), backplane, processor, cable, or other components
Detailed Description
Multiple issues are observed in the System Configuration Check operation.
Recommended Response Action
Do the following and retry the operation:
Disconnect the input power.
Check for proper cable connection and component placement. If the issue persists, contact the service provider.
Category
System Health (HWC = Hardware Config)
Severity
Critical
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\