NOTE:The BIOS information that is provided is related to the
Dell PowerEdge 16G line of systems. The information is applicable to all
Dell APEX Cloud Platform offerings.
Use the
System Setup option to configure the system BIOS, iDRAC, and device settings.
Use one of the following interfaces to access the
System Setup:
iDRAC UI - From the
iDRAC Dashboard, click
Configurations, and then click
BIOS settings.
Text browser - To enable the text browser, use the
Console Redirection option.
Steps
To view the
System BIOS screen, power on the system and press
F2 during the boot process.
Click
System Setup Main Menu.
NOTE:If the operating system begins to load before you press
F2, wait for the system to finish booting, and then restart the system and try again.
The following table describes the options available in the
System Setup Main Menu:
Table 1. System Setup Main Menu This table describes the options available in the System Setup Main Menu.
Option
Description
System BIOS
Configure the BIOS settings.
iDRAC Settings
Interface to set up and configure the iDRAC parameters by using Unified Extensible Firmware Interface (UEFI). You can also enable or disable various iDRAC parameters. For more information about this utility, go to the
Dell Support site and select the version and series of iDRAC that you have installed.
Device Settings
Configure the settings for devices such as storage controllers or network cards.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\