The system health and system ID indicator is on the left control panel of the system.
Figure 1. System health and system ID indicator
The following table provides information about the system health and system ID indicator codes for the
MC-760.
Table 1. System health and system ID indicator codesThis table provides information about the system health and system ID indicator codes for the
MC-760.
System health and ID indicator code
Condition
Solid blue
Indicates that the system is powered on, is healthy, and system ID mode is not active. Press the system health and system ID button to switch to system ID mode.
Blinking blue
Indicates that the system ID mode is active. Press the system health and system ID button to switch to system health mode.
Solid amber
Indicates that the system is in fail-safe mode. If the problem persists, see
Additional support.
Blinking amber
Indicates that the system is experiencing a fault. Check the System event log for specific error messages. For information about the event and error messages that are generated by the system firmware and about the agents that monitor system components, go to
Dell Quick Resource Locator. Click
Look Up,
Error Code, type the error code, and then click
Look it up.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\
