To enable communication between your system and iDRAC, you must first configure the network settings that are based on your network infrastructure. By default, the
Network settings option is set to
DHCP. For static IP configuration, you must request the settings at the time of purchase.
To set up the iDRAC IP address, use one of the interfaces in the following table:
Table 1. Interfaces to set up iDRAC IP addressThis table provides information about the interfaces to set up an iDRAC IP address.
Interface
Documentation links
iDRAC Settings utility
From the
iDRAC Manuals page, select the iDRAC software that you are using. From the
Documentation section, locate the
Integrated Dell Remote Access Controller User's Guide. You can also go to
Dell Support and search for your specific product in the
Identify your product box.
NOTE:To determine the most recent iDRAC release and for the latest documentation version, see
KB 000178115.
OpenManage Deployment Toolkit
From the
OpenManage Manuals page, select
OpenManage Deployment Toolkit from the Enterprise Systems Management column, then select the appropriate version. In the
Documentation section, select the
Dell OpenManage Deployment Toolkit User's Guide.
iDRAC Direct
See the
Integrated Dell Remote Access Controller User's Guide at
iDRAC Manuals. You can also go to
Dell Support and search for your specific product in the
Identify your product box.
NOTE:To determine the most recent iDRAC release and for the latest documentation version, see
KB 000178115.