- Notes, cautions, and warnings
- Revision history
- Introduction
- Overview
- Technical specifications
- Initial system setup and configuration
- Pre-operating system management applications
- BIOS and iDRAC settings
- Set up the system
- Dell Lifecycle Controller
- Boot Manager
- Configuration information
- System diagnostics and indicator codes
- Additional support
Dell APEX Cloud Platform MC-660 Hardware Requirements and Specifications
NVMe settings
In the BIOS, access NVMe Settings to view details.
Steps
- To view the NVMe Settings screen, power on the system and press F2.
-
Click
System Setup Main Menu,
System BIOS, and then
NVMe Settings. The following table lists the options available:
Results
| Option | Description |
|---|---|
| NVMe Mode | Enables or disables the boot mode. By default, this option is set to Non-RAID mode. |
| BIOS NVMe Driver | Sets the drive type to boot the NVMe driver. The available options are Dell Qualified Drives and All Drives. By default, this option is set to Dell Qualified Drives. |
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\