The iDRAC Direct LED indicator lights up to indicate that the port is connected and is being used as a part of the iDRAC subsystem.
You can configure iDRAC Direct by using a USB to micro USB (type AB) cable, which you can connect to your laptop or tablet. Cable length should not exceed 0.91 m (3 ft). Cable quality can affect the performance. The following table describes iDRAC Direct activity when the iDRAC Direct port is active:
Table 1. iDRAC Direct LED indicator codesThis table describes the iDRAC Direct LED indicator codes.
iDRAC Direct LED indicator code
Condition
Solid green for two seconds
The laptop or tablet is connected.
Blinking green (on for two seconds and off for two seconds)
The connected laptop or table is recognized.
LED Indicator off
The laptop or tablet is unplugged.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\