When the system is powered on, information about the following is obtained from the CPLD, and backplane memory maps and analyzed:
Installed cables
Risers
Backplanes
Power supplies
Floating card (fPERC, adapter PERC, BOSS)
Processor
This information forms a unique configuration. iDRAC maintains qualified configurations that are stored in a table. iDRAC compares the new configuration to the configurations in the table.
One or more sensors are assigned to each of the configuration elements. During POST, any configuration validation error is logged in the
System Event Log (SEL) or LifeCycle (LC) log. The reported events are categorized in the following configuration validation error table.
A configuration element in the closest match contains something that is unexpected and does not match any
Dell Technologies qualified configuration.
Wrong configuration
Config Error: Backplane cable CTRS_SRC_SA1 and BP-DST_SA1
The elements that are reported in HWC8010 errors indicate that an element is incorrectly assembled. Check the placement of the element, such as the cable or riser, in the system.
Config Error: SL Cable PLANAR_SL7 and CTRL_DST_PA1
Config Missing
iDRAC found a configuration element missing in the closest match detected.
Missing or damaged cable, device, or part.
Config Missing: Float card front PERC/HBA adapter PERC/HBA
Missing element or cable is reported in HWC8010 error logs. Install the missing element, such as the cable or riser.
Config Missing: SL cable PLANAR_SL8 and CTRL_DST_PA1
Comm Error
A configuration element is not responding to iDRAC using the management interface while running an inventory check.
System management sideband communication
Comm Error: Backplane 2
Unplug AC Power, reseat the element, and replace the element if the problem persists.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\