Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Alienware x15 R2 Service Manual

Installing the rear I/O-cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the rear I/O-cover and provides a visual representation of the installation procedure.

Image: Installing the rear I/O-cover

NOTE:To avoid damaging your computer, ensure that the Tron-light cable is not pinched when sliding the rear I/O-cover into palm-rest and keyboard assembly.

Steps

  1. With the correct orientation, slide the rear I/O-cover into the palm-rest and keyboard assembly, and snap it into place.
  2. Slide the left and right Tron-light cables into their respective connectors on the system board and close the latches to secure the cables.
    CAUTION:Do not pull at the bend points of the Tron-light cables and check for damage while removing and installing.
  3. Replace the two screws (M2.5x9) that secure the rear I/O-cover to the palm-rest and keyboard assembly.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\