Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Alienware m17 R4 Service Manual

Installing the 2230 solid-state drive from the M.2 slot three

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE M.2 slot three only supports 2230 solid-state drive.
NOTE A thermal shield is required for optimal heat dissipation if the capacity of the solid-state drive is 512 GB or higher. If a higher configuration solid-state drive is installed after you purchase the computer, contact Dell support to purchase a thermal shield.

The following image indicates the location of the 2230 solid-state drive that is installed in M.2 slot three and provides a visual representation of the installation procedure.

Image: Installing the M.2 2230 solid-state drive

Steps

  1. Align the notch on the M.2 2230 solid-state drive with the tab on the M.2 card slot on the left I/O-board.
  2. Slide the M.2 2230 solid-state drive into the M.2 card slot on the left I/O-board.
    NOTE The next step is only applicable if the capacity of the solid-state drive is 512 GB or higher.
  3. Place the solid-state drive thermal shield on the M.2 2230 solid-state drive.
  4. Replace the two screws (M2x3) that secure the M.2 2230 solid-state drive and the solid-state drive thermal shield to the left I/O-board.

Next steps

  1. Install the base cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\