Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Alienware m17 Service Manual

Procedure

  1. Open the hinges to 90 degree and place the display assembly on the palm-rest assembly by rotating outward.
  2. Replace the two screws (M2.5x4.5) that secures the display hinges to the palm-rest assembly.
    Image: Replacing the display assembly
  3. Close the display and place the computer on a clean and flat surface.
  4. Slide the display cable into the connector on the system board and close the latch to secure the cable.
  5. Adhere the tape that secures the display-cable connector latch to the system board.
  6. Connect the camera cable to the system board and adhere the tape that secures the camera cable to the system board.
  7. Place the power-adapter port into the slot on the palm-rest assembly.
  8. Place the power-adapter port bracket onto the power-adapter port, aligning the screw holes on the power-adapter port to the screw holes on the palm-rest assembly.
  9. Replace the two screws (M2x3) that secure the power-adapter port bracket to the palm-rest assembly.
    Image: Replacing the display assembly

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\