Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Alienware m17 Service Manual

Procedure to replace M.2 2280 card

NOTE This procedure applies only to systems shipped with a M.2 2280 card installed.
NOTE Depending on the configuration ordered the system may have up to two M.2 cards installed. Supported card configurations per M.2 card slot:
  • M.2 2230 solid-state drive + 2230 card bracket
  • M.2 2280 solid-state drive
  • M.2 2280 Intel Optane
NOTE For solid-state drives above 512 GB or Intel Optane above 118 GB a thermal shield is required for optimal heat dissipation and is installed in the computer when these configurations are ordered. If these configurations are installed After Point-of-Sale (APOS), contact Dell support for the thermal shield.
NOTE Depending on the number of M.2 cards installed at Point-of-Sale, the thermal shield installed in the computer may be a full shield or a half shield. If two M.2 cards are installed After Point-of-Sale (APOS) contact Dell support for the full thermal shield.
  1. Align the notch on the M.2 2280 card with the tab on the M.2 card slot on the system board.
  2. Slide the M.2 2280 card into the M.2 card slot on the system board.
  3. Replace the screw (M2x3) that secures the M.2 2280 card to the palm-rest assembly.
    Image: Replacing the M.2 2280 card
  4. Align the screw holes of the M.2 thermal shield with the screw holes on the palm-rest assembly and system board.
  5. Replace the two screws (M2x3) that secure the M.2 thermal shield to the palm-rest assembly and system board.
    Image: Replacing the M.2 2280 card

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\