Alienware m15 R6 Service Manual

Installing the power-adapter port

1. Lift the system board Mylar next to the left fan to access the power-adapter port slot.
2. Place the power-adapter port into the slot on the system board.
3. Connect the power-adapter port cable to the system board.
4. Adhere the power-adapter port cable on the system board.
5. Align the screw holes on the power-adapter port bracket to the screw holes on the system board.
6. Replace the two screws (M2x4) that secure the power-adapter port bracket to the system board.
7. Replace the system board Mylar back to the edge of the left fan.
8. Route the display cable through the opening between the power-adapter port and the heat-sink assembly.
9. Connect the display cable on the system board and close the latch to secure the cable.
10. Connect the Alienhead LED cable to the system board.
11. Adhere the display cable to the system board.