Aurora R7 Service Manual

Procedure

Lay the computer on the right side.
Disconnect the power cable from the U.2 solid-state drive.
Slide the power-supply unit cage release latches towards the unlock position.
Lift the power-supply unit cage while pressing and holding the graphics-card bracket.
Slide the fan cable and the data and power cable through the power-supply unit cage.
Disconnect the fan cable from the system board.
Disconnect the power cable from the power-supply unit.
Disconnect the data cable from the connector on the solid-state drive.
Slide the solid-state drive adapter to the solid-state drive slot and remove the screw that secures the solid-state drive adapter to the system board.
Press the release tabs on the hard-drive carrier and slide the U.2 solid-state drive out of the hard-drive cage.
Figure 1. Removing the hard drive
1. data cable
2. power cable
3. hard-drive cage
4. release tabs
5. hard-drive carrier
Remove the tabs U.2 solid-state drive from the slots on the hard-drive carrier and lift the U.2 solid-state drive.
Figure 2. Assembling the U.2 solid-state drive
1. hard-drive carrier
2. fan cable
3. U.2 solid-state drive