- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Inside view of your computer
- System-board components
- Recommended tools
- Screw list
- Antenna
- Cable cover
- Left-side cover
- Top cover
- Right-side cover
- Front bezel
- Side light
- 2.5-inch hard drive
- 3.5-inch hard drive
- Power-supply unit
- Coin-cell battery
- Memory module
- Single-graphics card
- Solid-state drive
- Removing the 2230 solid-state drive in SSD slot one
- Installing the 2230 solid-state drive in SSD slot one
- Removing the 2280 solid-state drive in SSD slot one
- Installing the 2280 solid-state drive in SSD slot one
- Removing the 2230 solid-state drive in SSD slot two
- Installing the 2230 solid-state drive in SSD slot two
- Removing the 2280 solid-state drive in SSD slot two
- Installing the 2280 solid-state drive in SSD slot two
- Processor fan and heat-sink assembly
- Processor liquid-cooling assembly
- Liquid-cooling assembly fan
- Processor
- Wireless card
- SMA cable
- Rear-chassis fan
- Lower front-chassis fan
- Upper front-chassis fan
- Top-chassis fan
- VR heat sink
- System board
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Alienware Aurora R15 Service Manual
Installing the antenna
About this task
This computer is shipped with an external puck antenna. Connect the external antenna during setup, to connect to WiFi and Bluetooth and improve the memory performance. To connect the antenna cables, follow the below procedure:
Steps
- Align and connect the antenna cables to the SMA connectors on the chassis.
- Tighten the bolts to secure the antenna cables to the SMA connectors on the chassis to connect the external antenna to the computer.
Next steps
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\