- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Inside view of your computer
- System-board components
- Recommended tools
- Screw list
- Antenna
- Cable cover
- Left-side cover
- Top cover
- Right-side cover
- Front bezel
- Side light
- 2.5-inch hard drive
- 3.5-inch hard drive
- Power-supply unit
- Coin-cell battery
- Memory module
- Single-graphics card
- Solid-state drive
- Removing the 2230 solid-state drive in SSD slot one
- Installing the 2230 solid-state drive in SSD slot one
- Removing the 2280 solid-state drive in SSD slot one
- Installing the 2280 solid-state drive in SSD slot one
- Removing the 2230 solid-state drive in SSD slot two
- Installing the 2230 solid-state drive in SSD slot two
- Removing the 2280 solid-state drive in SSD slot two
- Installing the 2280 solid-state drive in SSD slot two
- Processor fan and heat-sink assembly
- Processor liquid-cooling assembly
- Liquid-cooling assembly fan
- Processor
- Wireless card
- SMA cable
- Rear-chassis fan
- Lower front-chassis fan
- Upper front-chassis fan
- Top-chassis fan
- VR heat sink
- System board
- Drivers and downloads
- System setup
- Troubleshooting
- Getting help and contacting Alienware
Alienware Aurora R15 Service Manual
Removing the cable cover
Prerequisites
- Follow the procedure in Before working inside your computer.
About this task
The following image indicates the location of the cable cover and provides a visual representation of the removal procedure.
NOTE:The cable cover is an optional accessory.
Steps
Pull the cable cover from the top to lift the cable cover from the chassis.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\