Alienware Aurora R15 Service Manual

Installing the single-graphics card (with screw)

If you are replacing a component, remove the existing component before performing the installation procedure.

The following images indicate the location of the single-graphics card and provide a visual representation of the installation procedure.

Image: Installing the graphics card

Place the card into the PCIe slot and press down firmly until the single-graphics card snaps into place.
Close the expansion-card door and snap the latch back into position.
Replace the screw (#6-32) that secures the graphics-card bracket to the chassis.
NOTE:Skip this step if your graphics card does not ship with a graphics-card bracket.
Connect the graphics-card power cables to the graphics card.
Align and place the graphics-card end holder on the lower front-chassis fan and slide the latch to its lock position.
NOTE:Skip this step if your graphics card does not ship with a graphics-card end holder.